Remote Audio SpeakEasy v4BT Bluetooth Battery Powered Monitor Speaker

£348.96 (£290.80 Exc. VAT)
In stock now
Remote Audio SpeakEasy v4BT Bluetooth Battery Powered Monitor Speaker
Remote Audio SpeakEasy v4BT Bluetooth Battery Powered Monitor Speaker
Remote Audio SpeakEasy v4BT Bluetooth Battery Powered Monitor Speaker

Remote Audio SpeakEasy v4BT Bluetooth Battery Powered Monitor Speaker

£348.96 (£290.80 Exc. VAT)
In stock now
Brand: Remote AudioModel: SpeakEasy V4BT
+
Key Features:
  • Bluetooth operation for wireless playback
  • Cast aluminium enclosure with a durable finish
  • Small enough to hide on set
  • Powered by 9V batteries or external DC
See More...
S-REM-SPKEZV4BT
Information

Remote Audio SpeakEasy v4BT Bluetooth Battery Powered Monitor Speaker

The Speakeasy v4BT is a self-contained, battery-powered speaker with mic, line and instrument level inputs, and an integrated Bluetooth receiver for wireless playback of audio. It is housed in a cast aluminium enclosure with a durable black finish and features an improved audio signal path and upgraded power amplifier for better clarity and faithful sound reproduction.The Speakeasy v4BT drivers are magnetically shielded, allowing operation near sensitive equipment.

Powering

The Speakeasy v4BT will operate on two 9V batteries, typically for a full day of intermittent use. It will also operate from an external 9 - 18VDC power source on its coaxial power connector (2.1 x 5.5mm, center pin positive). The internal battery is switched out of circuit when plugging in external power so there is no need to remove the battery when using external power.

Line Level Input

The line level input is for balanced signals of +4dB, though unbalanced signals may be used. An XLR / 1/4" TRS combo jack is provided for convenience, and is wired in the standard balanced configuration of Pin 1/Sleeve = Ground, Pin 2/Tip: Audio Hot (+), Pin 3/Ring: Audio Cold (-).

Microphone Level Input

The XLR mic level input will accept a balanced mic level signal, and will directly accommodate a dynamic microphone. Powering for condenser mics is not available. The microphone input has 40dB of gain available, accessible on the rear panel with a small flat-bladed screwdriver.

Instrument Level Input

The Speakeasy v4BT will accommodate an unbalanced instrument-level signal on a 1/4" TS connector. The impedance of this input is 1Mohm, which is suitable for use with passive electric guitar pickups or active guitar preamp systems without "loading down" the pickups and causing high frequency roll-off. Instruments with very hot outputs, such as electric guitars with overwound humbucker pickups, may cause distortion. In that case, the guitar's volume control should be adjusted to minimize distortion. All audio inputs are isolated from each other and therefore may be used at the same time. For example, a line level input can be used for music playback while the mic input is used for cueing.

Bluetooth Operation

The Speakeasy v4BT is equipped with a built in bluetooth receiver module for wireless audio playback. It has a range of >30 ft. depending on the environmental factors. It features a simple two button interface with two status LEDs.

Applications

  • Use on your cart to listen without headphones.
  • Place it anywhere on set with a wireless receiver for cueing and stage announce.
  • Plant it in a car during tow scenes so the director can talk to actors (when used with the Boom Box).
  • Connect one (or two) to your computer or iPod for remote listening and editing.
  • Monitor programming during remote radio and television broadcasts.
  • Plant it inside a piano for realistic track playback.
Specifications

Specifications

Dimensions 11.6 x 11.4 x 18.5 cm (4.6" x 4.5" x 7.3")
Weight 1.99 kg
Internal Power Two 9V batteries
External Power 9-18VDC
Idle Power Drain ~70mA
Amplifier Power 14W per channel
Woofer 8 Ohm nominal speaker impedance
Tweeter 6 Ohm nominal speaker impedance
Maximum SPL 96dB (1kHz @ 1m)
Blutooth Version 5.0 certified
Support A2DP v1.2, AVRCP v1.5 HSP v1.1
Frequency Spectrum 2.402 GHz to 2.480 GHz
Range approx 30 - 50ft depending on environmental factors
Reviews (0)

Be the first to Write a Review for this item!

Hire

Hire Equipment

We have an extensive inventory of audio equipment for hire with competitive rates ready at a moment's notice. We pay the most meticulous attention to detail in our hire prep so you can travel to shoots with the peace of mind that you have everything you need.

Weekly Rental

For weekly rental, you can pick up your gear the day before your production shoot after 3:00pm, and return by 10:00am after your shoot day. In the case of 7 day rental, you will only be charged for 4 billing days.

Shipping

If shipping is required, we require a two day minimum hire period, with a travel day inbetween.

Cancellations

Orders can be cancelled for free up to 24 hours before pick up date, any notice within 24 hours of the pick up date will be charged a prep fee of 25% of the total amount.

Insurance

Customers will provide a certificate of insurance listing Everything Audio as "loss payee" and "additional insured".

*
*
Existing Customer
*
*
Please provide your contact telephone number.
*
Please provide the name and model of the product(s) you are enquiring about hiring.
*
What is the date range that you are looking to hire this/these product(s) for?
*
Please add the two numbers